MAGNETIC FIELD SENSOR (B)
(FREE FIELD)
MODEL B-10 (A or R)
DESCRIPTION
The PRODYN Model B-10 sensor is a B-dot loop equivalent to the
AFWL Model MGL-1. The sensor is a full cylinder loop that measures
the time rate-of-change of a magnetic field. For this type of
measurement,the sensor should be supported by di-electric materials
and placed not closer than two sensor diameters from conducting surfaces. The sensor design consists of a cylinder which contains four equally spaced longitudinal gap structures. The voltage developed across each gap is carried on pairs of 200-ohm transmission lines, which at opposite gaps are connected in parallel to 100-ohm cables. These cables in turn are connected to the 100-ohm twinax output cable. This design is effectively a half-turn loop driving the output connector. The gap and wiring configuration used causes any responses to electric fields to be cancelled, and the sensor's output signal to result from only magnetic fields. The equation relating to the sensor is:
g
Vo = Aeq . dB = sensor output (in volts)
dt
where
g
Aeq = sensor equivalent area (m2)
g
B = magnetic flux density vector (teslas)
The sensor is a passive device; therefore, an external power source is not required. It is equipped for purging with a gas such as dry air, nitrogen, or SF6. It is available with an axial output, Model B-10(A), or a radial output, Model B-10(R).
ELECTRICAL SPECIFICATIONS
Equivalent Area (Aeq) . . . . . . . . . . 1 x 10-1 m2
Frequency Response (3 dB Point) . . . . > 120 MHz
Risetime (tr 10-90) . . . . . . . . . . . < 3.0 ns
Maximum Output (peak) . . . . . . . . . . ± 5 kV
Output Connector . . . . . . . . . . . . 100 ohm Twinax
(Modified GR-874)
PHYSICAL SPECIFICATIONS
ORDERING INFORMATION
* Customer to specify axial (A) or radial (R) version.
