MAGNETIC FIELD (B.) & SURFACE CURRENT (J.) SENSOR
MODEL B-S50
DESCRIPTION
The PRODYN Model B-S50 sensor is a B-dot loop equivalent to the AFWL Model MGL-S5. This sensor can be used as a B-dot, or it can be used to measure the time rate-of-change of surface current density since the magnetic field over a conductive sheet is related to surface current density. The sensor consists of a half-cylinder loop on a base plate that when mounted to a conducting surface produces a voltage output in response to a time variant B field. The B-S50 is basically identical to the Model B-50. The differences are a smaller sensor base plate to facilitate mounting and connector placement on the B-S50 versus B-50.
This sensor has a parallel-series wiring configuration that cancels the electric field induced signals and makes the sensor's output signal the result of only the magnetic field. The equation pertinent to this device when used as a B-dot sensor is provided on the Model B-50 Data Sheet. The equation to surface current density measurements is:
Vo = Aeq mo dJs sin q = sensor output (in volts)
dt
where
Aeq = sensor equivalent area (m2)
mo = permeability of free space (4p x 10-7 m)
Js = surface current density (Amps/m)
sin q = angle between sensor axis and Js vector
The sensor is a passive device; therefore, an external power source is not required. The sensor is equipped for purging with a gas such as dry air, nitrogen, or SF6. The sensor is available with an axial output, Model B-S50(A), or a radial output, Model B-S50(R).
ELECTRICAL SPECIFICATIONS
Equivalent Area (Aeq) . . . . . . . . . . 1 x 10-3 m2
Frequency Response (3 dB Point) . . . . > 700 MHz
Risetime (tr 10-90) . . . . . . . . . . . < 0.5 ns
Maximum Output (peak) . . . . . . . . . . ± 5 kV
Output Connector . . . . . . . . . . . . 50 W GR-874**
PHYSICAL SPECIFICATIONS
ORDERING INFORMATION
Customer to specify axial (A) or radial (R) version.
** This can be changed to a Type N, SMA, etc. (Max output voltage will be affected.)